Erasing an unruly stain from your home’s wall is not an easy feat. The reason is that stains are tough to remove and do not completely go away after so many trials.
Magic erasers are for cleaning dents from your walls without having to repaint the entire wall.
Unfortunately, this dissolver leaves some marks on the walls that are more noticeable over time.
The good thing is that there is a solution to this problem, although it depends on a few factors.
Like if there is paint on the wall, the type of paint, and the most affordable way to tackle the problem.
Magic erasers leave marks on the wall despite being a cleaning agent. It is troubling, especially for people who cannot stand any imperfection in their surroundings. However, you can remove the marks by repainting and cleaning with alcohol, soap, and water.
Magic Eraser Left Dark Marks on Wall
Fetching a magic eraser immediately after your kid rubs some chocolate on your wall is reasonable.
Let us say chocolate wipes easily; how about some strawberry juice with a high concentration? These kinds of stains take forever to go away.
Most times, the stain expands when you attempt to clean it with a wet piece of cloth. But, unfortunately, this action never leaves a good impression.
Hence, you must know how to clean correctly without causing a mess, and lucky for you, we will find out later in this article.
One primary disadvantage of using magic erasers is that it doesn’t only leave a dark mark, it makes the site appear dull.
It would appear unattractive and quite apparent for a wall with oil paint. It’s not hard to miss a dry patch on a glossy surface.
The dullness does not just affect glossy surfaces, and it also applies to walls with flat paints.
Even though walls with flat paints are not glossy, it doesn’t stop the uneven appearance when you clean with magic erasers.
The first thing to do when you notice a stain on the wall is to get safer-effects water. This solution can remove even some tough stains.
It involves the sodium in the soap breaking the bonds between the dirt particles after reacting with water.
Aside from walls, soap and water is best for washing clothes and removing tough stains. However, some stains are adamant no matter how hard you scrub.
You must be careful if you have this type of dent on your wall; applying too much pressure will only destroy your paint. Therefore, causing more harm than good.
You should not worry about magic erasers leaving a dark mark on your wall if you didn’t apply paint.
The reason is that the dark residual mark is more visible on light-colored walls. For example, if you have wooden walls, the dark stain may not be noticeable.
If tiles are on your surface, they will hardly leave any mark; tiles surfaces are smooth and cannot absorb stains or liquids.
This feature makes it best for large families; you don’t worry about kids painting the walls with whatever they see.
How to Remove Magic Erasers From Walls?
Removing a magic eraser from your wall is relatively easy. As long as you have the suitable materials and tools, you know what to do and how to do it correctly.
There are different surfaces; some have paint on them while others do not.
For walls that have paint on them, it could have oily surfaces or flat surfaces. Each of these variations gives rise to different methods by which you can remove the mark that the magic eraser leaves.
Aside from using soap and water, there are a few things you can use to help remove the dark residual mark from a magic eraser.
Examples are; vinegar, alcohol, olive oil or any other mild oil, and baking soda.
These cleaning agents differ in their concentration, efficiency, and after-effects. So, your choice should depend on the dent’s impact or your preference.
It would help if you knew that vinegar is the preferred cleaning agent. There are a few differences between vinegar and soapy water.
Here is a table that contains the differences in their composition that makes them unique.
| Vinegar | Soapy Water |
|---|---|
| The primary component is acetic acid, an unbeatable cleaning agent. | A mixture of sodium hydroxide ions and water can loosen bonds in stains and allows for effective cleaning. |
| Higher concentration of about 2.5 | Lower concentration of about 7.5-8. |
| It is advisable to mix the vinegar and water in a ratio of 0.5 to 1. The reason is that the concentration of vinegar is relatively high and requires dilution before usage. | The soapy water is already a solution. |
| One disadvantage of using vinegar if your wall is from wood is that it might fade the paint on the site if you don’t mix the right amount of water. | One disadvantage of using soapy water is that it might not remove the stain because of its concentration. |
Now that we know the differences between these two, I hope it will help us make a choice.
Finally, here are the steps to remove magic erasers from walls.
- First, decide on the cleaning agent you want to use: vinegar, soapy water, or oil.
- Each of these agents requires various cleaning methods. Therefore, we will discuss each cleaning agent and the most suitable method.
#1. Vinegar or Alcohol
These steps are as follows;
- Get two small towels or sponges for wiping.
- Mix the vinegar with water in ½ to 1 respectively in a small bowl or spray bottle.
- Using the spray bottle, apply some solution to the wall and wipe gently with the towel. On the other hand, when using a bowl, dip the towel in the bowl and squeeze out the excess moisture. Next, rub the site until the mark is no longer apparent.
- Finally, dry the area with a dry towel to remove residual moisture, then leave to air dry.
#2. Soapy Water
- First, mix the mild soap dish in a water bowl, then get two towels; one for drying and the other for cleaning.
- Dip the towel in the solution and wipe the dark mark repeatedly until satisfied with the results.
- Dry with a clean towel and observe.
#3. Olive Oil
Olive oil is best for glossy surfaces.
- Take a paper towel and touch some oil from the bottle.
- Rub it over the site on the glossy surface with the dark mark.
- Be careful not to use too much oil so you do not leave a wet stain on the area. This action will defeat the whole process.
- Wipe appropriately with a clean towel and leave to air dry.
Are Magic Erasers Safe on Walls?
Magic erasers are safe on walls that do not have glossy surfaces or are already dull in appearance.
For example, you can use magic erasers on walls that do not have oil paint. The reason is that the harsh cleaner will strip the surface of its glossiness, rendering that site uneven in appearance.
Unfortunately, nobody wants to repaint their wall because of a tiny stain. However, this action could be the last resort when you’re not careful.
You do not need to worry, granted that you follow the step-by-step guide on how to clean your surface to remove the dark mark.
Moreover, I would recommend using Scrubit magic erasers; they are safe for walls.
No products found.
Can a Magic Eraser Remove Paint on a Wall?
Magic Erasers will not remove paint on walls unless you rub on a particular spot for a long time.
The only effect magic erasers will have on your surface is that; they will reduce the intensity and sometimes leave a dark mark.
Apart from these, it is not unhealthy or dangerous, and nor is it toxic.
Final Thoughts
In conclusion, magic erasers can leave a dark mark on your wall’s surface. This flaw is an unenviable disadvantage that affects the credibility of this cleaner.
Consequently, it leaves your surface in a worse state than you met it when there was a stain.
However, your problem is solved as long as you use the proper cleaning agents or even go ahead to repaint the wall.
